Interfaces
- 1 Combo-port 10/100/1000Base-T (Ethernet) / 100/1000Base-X (SFP)
- 2 SMA-type connectors (female) for external antennas (Omni, sector, rod, etc.)
WLAN capabilities
- Support for IEEE 802.11a/n/ac
- Data aggregation, including A-MPDU (Tx/Rx) и А-MSDU (Rx)
- Priorities and packed planning based on WMM
- Dynamic frequency selection (DFS)
- Hidden SSID support
- 4 virtual access points
- External access points detection
- APSD
- Spectrum analyzer
- Support for wireless bridges (WDS)
- Polling
- Support for central fixed frequency
Network function
- Automatic negotiation of speed and duplex mode, switching over MDI and MDI-X modes
- Support for VLAN
- 802.1X authentication support
- DHCP-client
- Support for ACL
- Support for NTP
- Support for Syslog
QoS functions
- Packet priorities and planning based on profiles
- Bandwidth limiting for each SSID
Security
- Centralized authentication via RADIUS server (WPA/WPA2 Enterprise)
- WPA/WPA2 encryption
- 64/128/152-bit WEP encryption of data
Wireless intarface parameters
- Frequency range 5170–6160 MHz
- BPSK, QPSK, 16QAM, 64QAM, 256QAM modulation
- Support for MIMO 2х2
- Wi-Fi Realtek RTL8812BRH chip
- Bandwidth: 5, 10, 20, 40, 80 MHz
Operation channels1
- 802.11a/n/ac: 36-230 (5170-6160 MHz)
Data rate2
- 802.11ac: up to 54 Mbps
- 802.11n: up to 300 Mbps
- 802/11ac: up to 867 Mbps
Receiver sensitivity
- 5-6 GHz: up to -94 dBm
Maximum power of the transmitter1
- 5-6 GHz: 24 dBm
Configuration
- Remote control via Telnet, SSH
- Web interface
- CLI
- NETCONF
Physical specifications
- Power consumption up to 6.5 W
- Processor Realtek RTL8197FS
- 32 MB Flash
- 128 MB RAM
- Power supply: PoE+ 48В/54В (IEEE 802.3at-2009)
- Operating temperature from -45°С to +65°С
- IP54 protection level
- Dimensions (WxHxD): 88×232.5×47 mm
- Pole mount
1 The number of channels and the value of the maximum output power will vary according to the rules of radio frequency regulation in your country.
2 The maximum wireless data rate is defined according to IEEE 802.11n/ac standard. The real bandwidth might be different. Conditions of thenetwork, environment, the amount of traffic, building materials and constructions and network service data might decrease the real bandwidth. The environment mightinfluence on the network coverage range.